detachable screen heating plate mobile phone

Jinsheng silica gel electric heating plate detachable screen treasure heating plate mobile phone flat panel split screen detachable screen heating plate silica gel electric heating film silica gel heating film silica gel heating sheet silica gel heater is mainly composed of Ni Cr alloy heating wire and glass fiber reinforced silicone rubber insulating cloth. It has the characteristics of fast heating, uniform temperature, high thermal efficiency, high strength, convenient use, long safety life, not easy to aging, can bend and deform the surface of the object, and can evenly convey the heat to every part in contact with the heated object.

Product parameters:

Economic section I:

Size: 300mm * 230mm, power line: 1.5m (with leakage protection plug), equipped with temperature control knob

Economic Section 2:

Size: 350 * 250mm, power line: 1.5m (with leakage protection plug), equipped with temperature control knob

General section I:

Size: 420mm * 250mm, power line: 1.5m (with leakage protection plug), equipped with temperature control knob

General section II

Size: 380 * 250mm, power line: 1.5m (with leakage protection plug), equipped with temperature control knob

Note: the temperature control can be replaced by digital display temperature control, which needs to be increased by 100 yuan

Product introduction:

Apple iPad screen removal treasure screen removal treasure screen removal heating pad replacement touch screen mobile phone tablet heating separation screen

Screen changing treasure adopts flexible heating material, which can heat more evenly than the hot air gun, and can quickly soften the rubber surface, so as to disassemble the screen more safely and conveniently. Greatly reduce the probability of breaking the screen, and the screen removal efficiency is higher

Applicable customers:

Repair shop and apple after-sales repair shop

instructions:

Usage: (tile the desktop, keep it flat, and place the temperature control knob on the left.)

Change iPad external screen:

The first step is to preheat the metal shell: adjust the temperature control knob to 60 degrees and face up for about 2 minutes.

Step 2: heat the periphery of the outer screen: turn the front outer screen down for about 2 minutes, turn it over and insert it into the gap of the outer screen with a crowbar or paddle

Check whether the glue surface is softened, and adjust the heating time or temperature according to the actual situation. After the rubber surface is softened, adjust the temperature control knob to 0 ° C or turn off the power supply, and use the residual temperature to keep the rubber on the casing in the softened state for disassembly.

Reminder: 1 After the adhesive surface softens, do not place the back of the iPad on the heating surface for too long.

2. With regard to adjusting temperature and time, each operator gradually finds a set of steps suitable for himself according to the actual situation.

matters needing attention

Tips for safe use:

Do not bend excessively to avoid damaging the internal heating parts.

The surface of the split screen treasure is insulated, but it is not waterproof. Therefore, do not wash it in water. Stay away from the water source during use to avoid short circuit.

In case of water splashing on the temperature control switch and heating surface, please cut off the power immediately (press the yellow button on the leakage protection plug to cut off the power). Avoid getting close to infants during use to avoid danger.

Do not cut or puncture the heating surface during use to avoid electric leakage.

During the heating process, do not place the iPad on the heating surface for too long to avoid damaging the motherboard and LCD.